OSN3500_SSN1_SSN4GSCC System Control Single Board Tuning and Configuration

Before installingthe GSCCsingle board on Huawei OSN3500 devices, you need to perform the necessary tuning and configuration of the single board. First of all, you should check the single board hardware to see whether the logo on the single board puller strip should be clear, whether the buckle plate is firm, whether the front and back sides of each device need to be complete, the surface is normal, and there are no obvious traces of damage.

After confirming the slot and the installation of the main and backup veneers in the Huawei OSN3500 device, the veneer should be inserted into the bottom of the subrack along the guide groove and the veneer handles should be fastened normally. Then observe the power-up process and the status of each indicator of the single board after completion. Check the single board with the host, network management of the version of the matching relationship, to ensure that the single board version matching the use of error-free.

Check theoperation of the ALM switch to confirm that a short press on the switch to remove the current alarm sound; long press the switchfor 5seconds to permanently remove the alarm sound, alarm removal indicator (ALMC) light (yellow); long press again to cancel the alarm removal function, alarm removal indicator (ALMC) off.

Huawei OSN3500 deviceGSCCsingle board must be added to the logical single board in terms of configuration. Ifthe configuration parameters of theGSCCsingle boardare available on the network management, the configuration parameters are directly downloaded tothe GSCCsingle board. Otherwise, you need to set the network elementIDand configure the network element name/date/time.

Huawei OSN3500 deviceGSCCsingle-board single-board debugging includes: checking the single-board debugging status jumper settings, checking and debugging the pass-through of the data ports, including the configuration ofthe F&fdebugging serial port and the configuration ofthe OAMserial port network management port, and checking the configuration of the data ports includes: configuring the broadcasting data ports, and configuringthe F1isotropic data ports.

Huawei OSN3500 equipmentGSCCsingle-board acceptance test need to observe the single-board indicator, by observing the status of the indicator on the pull handle bar, to see whether the single-board is normal to start work, the status light is all green means that the single-board operation is normal. Then query the single-board alarms and performance events, according to the alarms and performance modification of the single-board connection or configuration, until the disappearance of the relevant alarms in the optical transmission equipment. Related informationGSCCsingle-board specifications.