Description of the problem

1. The service networking is as follows: A-166 device 7-SLO1-1 is docked to a friendly device, and the service is landed to the 2-PQ1 single board of C-166.

2. Requirement: Configure a VC4 service layer path from port 7-SLO1-1 of A-166 network element to C-166 network element.

3, U2000 network management --- service --- create SDH path, level: VC4 service layer path, double-click to select the A-166 network element can not be selected after the 7-SLO1 single board port 1, can only directly select the network element, so that can not complete the need to configure.

Alarm message

No

Processing

1, U2000 network management --- business --- create SDH path, level: VC4 service layer path, select the source "Browse".

2, in the "Browse" interface, select A-166 network elements, check the lower left corner of the "Select the service layer path does not end (select to the single board/port/time slot)" and then successfully select the A-166 network elements docked to the friend of the equipment 7-SLO1-1 port, the problem is solved. The problem is solved.

Root Cause

not have

Solution

1. If the U2000 network administrator wants to create an unterminated VC4 service layer path, click "Browse", check the "Select unterminated end of service layer path (select to single board/port/time slot)" check box in the pop-up window, and select single board, port, time slot, and so on. Select the board, port, and time slot.

Recommendations and Summary

1, U2000 the probability of using the function is less, if you meet similar needs can refer to the case operation.

This chapter of related technical information and SDH equipment troubleshooting process by Shenzhen Optical Transmission Network Technology Co., Ltd (www.opticaltrans.com), reproduced please retain! Huawei SDH Optical Transmission Equipment, SDH Transmission Equipment Sales