Protection requirements

Appearance of theOSN3500 SSN1EFS0AEthernet processing single board
| Functions and Features | Description | ||
|---|---|---|---|
| Basic Functions | Processes 16-channel FE services. | ||
| Interface Type |
|
||
| Matching Outlet Board |
|
||
| Interface Characteristics | Working Mode |
FE electrical interface: supports self-negotiation, 100M full-duplex, 100M half-duplex, 10M full-duplex, 10M half-duplex. FE optical port: supports 100M full duplex. |
|
| Port Flow Control Mode | Self-negotiation | Supported (not supported for FE optical port) | |
| Non-self-negotiation | Support | ||
| Port status query/configuration | Supported | ||
| Interface type query | Support | ||
| Optical Power Threshold Setting | Not supported | ||
| Pluggable Optical Module | Not supported | ||
| Service Type | EPL | Supports PORT-based transparent transport. | |
| EVPL |
|
||
| EPLAN |
|
||
| EVPLAN |
|
||
| Service Specifications | Ethernet Data Frame Format | IEEE 802.3 | Supports |
| Ethernet II | Supported | ||
| IEEE 802.1 q/p | Supported | ||
| Frame Length Range | Support 1518Byte~9600Byte message length setting, support Jumbo frames up to 9600Byte. | ||
| Mapping Method | VC-12, VC-3, VC-12-Xv (x≤63), VC-3-Xv (x≤12) | ||
| Encapsulation Format | HDLC | Not supported | |
| LAPS | Not supported | ||
| GFP-F | Supported | ||
| MPLS Technology | Supported | ||
| VLAN Technology | Supports 4094 VLAN tags, VLAN technology meets IEEE 802.1q/p standard. | ||
| Maximum Uplink Bandwidth | Maximum uplink bandwidth is 2.5Gbit/s, supporting slot bandwidth adaption. | ||
| Maximum Bound Bandwidth | 48xVC-3 or 252xVC-12+36xVC-3 | ||
| VCTRUNK Specifications |
Quantity: 32 Configuration Features:
|
||
| Protection Methods | TPS | Support | |
| BPS | Not supported | ||
| PPS | Not Supported | ||
| DLAG | Not supported | ||
| LAG |
Supports manual link aggregation and load sharing to meet IEEE 802.3ad and IEEE 802.1AX standards. |
||
| LCAS | Enables dynamic bandwidth increase, dynamic decrease and protection functions, meeting ITU-T G.7042 standards. | ||
| LPT | Supports point-to-point LPT and point-to-multipoint LPT, meeting Huawei's internal protocol standards. | ||
| STP/RSTP | Supports broadcast message suppression and rapid spanning tree protocol, meeting the IEEE 802.1w standard. | ||
| MSTP | does not support | ||
| Synchronization | Synchronous Ethernet | Not supported | |
| 1588v2 | Not supported | ||
| Maintenance Features | ETH OAM |
|
|
| Test Frames | Supports test frames under Ethernet/GFP bearer mode. | ||
| Response Ping Function | Does not support | ||
| Port Mirroring | Supports mirroring of incoming ports. | ||
| Loopback Capability | Ethernet port PHY layer | Supports inner loopback | |
| Ethernet port MAC layer | Supports inner loopback | ||
| VC-4 level | Not supported | ||
| VC-3 Level | Not supported | ||
| VC-12 level | Not supported | ||
| RMON | Supports port-level Ethernet performance monitoring. | ||
| Soft Reset | Supports soft reset, which does not affect services. | ||
| Hard Reset | Support | ||
| Alarm and Performance | Provides rich alarms and performance events for easy device management and maintenance. | ||
| QoS |
|
||
| IGMP Snooping | Protocol Enable | Support | |
| Port Aging Time | Support for | ||
| Fast Leave | Not Supported | ||
| Unknown Multicast Message Discard | Not Supported | ||
| Static multicast table entries | Not supported | ||
| Hub/Spoke | Hub/Spoke | ||
| Flow Control | Port-based IEEE 802.3x flow control is supported. Description: Only EPL services support port-based flow control. |
||
| Traffic Monitoring | Port and VCTRUNK based traffic monitoring is supported. | ||
The SSN1EFS0A single board supports Layer 2 switching, MPLS, multicast, and other functions and features.
The specific functions and features of the SSN1EFS0A single board are shown in Table 1.