Description of the problem

After a frontline engineer sets up an N2PQ1 single-board port inner loop on an OSN3500 R8C02 version network element, the loopback is never automatically released, . The loopback was eventually lifted manually. On the other hand, other line veneers can automatically release the loopback after setting the loopback.

Alarm Message

:cfg-set-loop:7,1,inloop

51026 7 LOOP_ALM MN start 2011-08-11 20:27:26 None 0x01 0x00 0x01 0x00 0x00 0x00

Process

Manually unlock the tributary single board loopback.

Root cause

The mainframe has been modified in R7 pole later versions, and all branch circuit boards in R7 and later mainframe versions do not support unloopback. All line boards support automatic unloopback.

Recommendation and Summary

With the command :cfg-set-loop:7,1,inloop

Set inloop on port 1 of board 7.

You can use the following command to query whether the port currently in loopback state can be released automatically

:cfg-get-autoclearlist.

AUTOCLEAR-RECORD

optype bid port path

portloop 7 1 0

Tabular output method with corresponding fields:

OPTYPE : Type to be automatically cleared

BID : Board ID

PORT ： Port number

PATH : Channel number

This means that port 1 of board 7 can be automatically released from loopback.

This chapter of related technical information and SDH equipment troubleshooting process by the Shenzhen Optical Transmission Network Technology Co. Our company specializes in the sale of Huawei SDH optical transmission equipment and SDH transmission equipment.